DSE 704

*The Module DSE704 has been designed to monitor engine temperature, low oil pressure fail to start,

charge failure, over speed and under speed.

*Automatic mains (utility) supply monitoring

*Automatic shutdown when fault conditions are detected

*Manual start

*Engine pre-heat

*Engine monitoring and protection features

*Protected solid state (PSS) outputs

*Front panel mounting

*Front panel programming

*Remote start

*LED indicators

*Configurable timers

*Configurable outputs

*ransfers between mains (utility) and generator power

* On-site module configuration to match user requirements

* Multiple engine parameters are monitored simultaneously

DC Supply:	8 Volts to 35 Volts DC Continuous.
Cranking dropouts:	Able to survive 0 Volts for 50 mS, providing supply was at least 10 V before dropout and supply recovers to 5 Volts. This is achieved without the need for internal batteries.
Max. Current:	Operating 50mA
Max. Current:	Standby 10mA
alternator Input Range:	75 Volts (ph-N) to 277 Volts (ph-N) AC (+20%)
Mains Input Voltage:	15 – 277 Volts (ph-N) AC (+20%)
alternator Input Frequency:	50 - 60 Hz at rated engine speed (Minimum: 75V AC Ph-N) (Crank Disconnect from 15V Ph-N @ 20Hz)
	Overspeed +14% (+24% overshoot)
	Underspeed –20%
Mains Frequency:	50 – 60 Hz
Start Output:	1.2 Amp DC at supply voltage.
Fuel Output:	1.2 Amp DC at supply voltage.
Auxiliary Outputs:	1.2 Amp DC at supply voltage.
Dimensions:	125mm x 165mm x 28 mm
Charge Fail:	12 Volts = 8 Volts CF 24 Volts = 16 Volts CF
Operating Temperature Range:	-30°C to + 700C
Applicable Standards:	Compliant with BS EN 60950 Low Voltage Directive
	Compliant with BS EN 50081-2: 1992 EMC Directive
	Compliant with BS EN 61000-6-4: 2000 EMC Directive